| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| PX4 Autopilot contains a heap buffer overflow vulnerability in the sd_bench command that writes a four-byte block number into a user-supplied sized allocation. Attackers can invoke sd_bench with a block size below four bytes to overflow the heap buffer and potentially execute code or crash the system. |
| In the Linux kernel, the following vulnerability has been resolved:
bpf: Keep dynamic inner array lookups nullable
An ARRAY_OF_MAPS can use an array created with BPF_F_INNER_MAP as its
inner map template. A concrete inner array with a different max_entries
value can then replace the template.
After a successful outer map lookup, the verifier represents the
resulting map pointer using the inner map template. Const-key lookup
nullness elision consequently uses the template max_entries even though
the runtime helper uses the concrete inner map max_entries.
Do not elide lookup result nullness for maps marked with BPF_F_INNER_MAP,
because the template max_entries does not prove that the key is in bounds
for the concrete runtime map. |
| Internally found bugs present in Thunderbird 154, Thunderbird ESR 153.1 and Thunderbird ESR 140.14. Some of these bugs showed evidence of memory corruption or another security-relevant defect and we presume that with enough effort some of these could have been exploited. This vulnerability was fixed in Firefox 155, Firefox ESR 140.15, Firefox ESR 153.2, Thunderbird 155, Thunderbird 140.15, and Thunderbird 153.2. |
| In the Linux kernel, the following vulnerability has been resolved:
ntfs: avoid calling post_write_mst_fixup() for invalid index_block
ntfs_icx_ib_sync_write() calls post_write_mst_fixup() when ntfs_ib_write()
returns an error, intending to restore the buffer after a failed write.
However, ntfs_ib_write() returns an error immediately if
pre_write_mst_fixup() validation fails. The caller,
ntfs_icx_ib_sync_write(), interprets any error as a write failure
requiring rollback. It does not differentiate between I/O errors and
validation failures, and calls post_write_mst_fixup() anyway.
Since post_write_mst_fixup() assumes that the index_block contents is
correct, it doesn't perform the boundary checks, which results in
out-of-bounds memory access.
An attacker can craft a malicious NTFS image with:
- large index_block.usa_ofs offset, pointing outside the ntfs_record
- index_block.usa_count = 0, causing integer underflow
- or index_block.usa_count larger than actual number of sectors in the
ntfs_record, causing out-of-bounds access
KASAN reports describing the memory corruption:
==================================================================
BUG: KASAN: slab-out-of-bounds in post_write_mst_fixup+0x19c/0x1d0
Read of size 2 at addr ffff8881586c9018 by task p/9428
Call Trace:
<TASK>
dump_stack_lvl+0x100/0x190
print_report+0x139/0x4ad
? post_write_mst_fixup+0x19c/0x1d0
? __virt_addr_valid+0x262/0x500
? post_write_mst_fixup+0x19c/0x1d0
kasan_report+0xe4/0x1d0
? post_write_mst_fixup+0x19c/0x1d0
post_write_mst_fixup+0x19c/0x1d0
ntfs_icx_ib_sync_write+0x179/0x220
ntfs_inode_sync_filename+0x83d/0x1080
__ntfs_write_inode+0x1049/0x1480
ntfs_file_fsync+0x131/0x9b0
==================================================================
BUG: KASAN: slab-out-of-bounds in post_write_mst_fixup+0x1aa/0x1d0
Write of size 2 at addr ffff8881586c91fe by task p/9428
Call Trace:
<TASK>
dump_stack_lvl+0x100/0x190
print_report+0x139/0x4ad
? post_write_mst_fixup+0x1aa/0x1d0
? __virt_addr_valid+0x262/0x500
? post_write_mst_fixup+0x1aa/0x1d0
kasan_report+0xe4/0x1d0
? post_write_mst_fixup+0x1aa/0x1d0
post_write_mst_fixup+0x1aa/0x1d0
ntfs_icx_ib_sync_write+0x179/0x220
ntfs_inode_sync_filename+0x83d/0x1080
__ntfs_write_inode+0x1049/0x1480
ntfs_file_fsync+0x131/0x9b0
==================================================================
Let's move the post_write_mst_fixup() call to ntfs_ib_write().
The ntfs_ib_write() function calls pre_write_mst_fixup() at the beginning.
If the index_block contents is invalid, pre_write_mst_fixup() fails and
ntfs_ib_write() returns early without calling post_write_mst_fixup() on
bad index_block. |
| A stack out-of-bounds write vulnerability was found in gfs2-utils. In gfs2_edit, the di_height field from on-disk inode metadata is used as an array index without bounds checking, causing a stack buffer overflow that may lead to arbitrary code execution when processing crafted GFS2 filesystem images. |
| A stack out-of-bounds write vulnerability was found in gfs2-utils. In savemeta, the height value from on-disk inode metadata is used as a loop bound without bounds checking, causing a stack buffer overflow that may lead to arbitrary code execution when processing crafted GFS2 filesystem images. |
| In the Linux kernel, the following vulnerability has been resolved:
staging: rtl8723bs: fix OOB write in HT_caps_handler()
HT_caps_handler() iterates pIE->length bytes and writes into
HT_caps.u.HT_cap[], which is a fixed 26-byte array (sizeof struct
HT_caps_element). Because pIE->length is a raw u8 from an over-the-air
802.11 AssocResponse frame and is never validated, a malicious AP can
set it up to 255, causing up to 229 bytes of out-of-bounds writes into
adjacent fields of struct mlme_ext_info.
Truncate the iteration count to the size of HT_caps.u.HT_cap using
umin() so that data from a longer-than-expected IE is silently ignored
rather than written out of bounds, preserving interoperability with APs
that pad the element. An early return on oversized IEs was considered
but rejected: it would bypass the pmlmeinfo->HT_caps_enable = 1
assignment that precedes the loop, silently disabling HT mode for APs
that append extra bytes to the HT Capabilities IE. |
| Buffer overflow in GPU in Google Chrome on on Windows prior to 152.0.7977.75 allowed a remote attacker who had compromised the renderer process to execute arbitrary code outside the sandbox via a crafted HTML page. (Chromium security severity: High) |
| A security issue exists within FactoryTalk® Historian Machine Edition. An attacker with low-level authentication could exploit this vulnerability to achieve remote code execution on the affected device. |
| There is an out of bounds write vulnerability due to improper bounds checking resulting in a large destination address when parsing a DSB file with Digilent DASYLab. This vulnerability may result in arbitrary code execution. Successful exploitation requires an attacker to get a user to open a specially crafted DSB file. The vulnerability affects all versions of DASYLab. |
| In the Linux kernel, the following vulnerability has been resolved:
hwmon: (pmbus/adm1266) include PEC byte in pmbus_block_xfer read buffer
adm1266_pmbus_block_xfer() sets up the read transaction with
.buf = data->read_buf,
.len = ADM1266_PMBUS_BLOCK_MAX + 2,
but read_buf in struct adm1266_data is declared as
u8 read_buf[ADM1266_PMBUS_BLOCK_MAX + 1];
For a max-length block response (length byte = 255 + up to 1 PEC
byte), the i2c controller is told to write 257 bytes into a 256-byte
buffer, putting one byte past the end of read_buf. The same response
also makes the subsequent PEC compare
if (crc != msgs[1].buf[msgs[1].buf[0] + 1])
read a byte beyond the array.
Bump the read_buf declaration to ADM1266_PMBUS_BLOCK_MAX + 2 so the
buffer can hold the length byte, up to 255 payload bytes, and the PEC
byte the i2c_msg length already accounts for. |
| There is a memory corruption vulnerability recently
discovered in NI LabVIEW that may result in information disclosure or arbitrary
code execution. Successful exploitation requires an attacker to get a
user to open a specially crafted VI. This vulnerability affects NI
LabVIEW 2026 Q3 (26.3.0) and prior versions. |
| In the Linux kernel, the following vulnerability has been resolved:
USB: serial: digi_acceleport: fix write buffer corruption
The digi_write_inb_command() is supposed to wait for the write urb to
become available or return an error, but instead it updates the transfer
buffer and tries to resubmit the urb on timeout.
To make things worse, for commands like break control where no timeout
is used, the driver would corrupt the urb immediately due to a broken
jiffies comparison (on 32-bit machines this takes five minutes of uptime
to trigger due to INITIAL_JIFFIES).
Fix this by adding the missing return on timeout and waiting
indefinitely when no timeout has been specified as intended.
This issue was (sort of) flagged by Sashiko when reviewing an unrelated
change to the driver. |
| In the Linux kernel, the following vulnerability has been resolved:
USB: serial: keyspan_pda: fix information leak
The write() callback is supposed to return the number of characters
accepted or a negative errno. Since the addition of write fifo support
the keyspan_pda implementation will however return the number characters
submitted to the device if the write urb is not already in use. If this
number is larger than the number of characters passed to write(), the
line discipline continues writing data from beyond the tty write buffer.
Fix the information leak by making sure that keyspan_pda_write_start()
returns zero on success as intended. |
| In the Linux kernel, the following vulnerability has been resolved:
staging: rtl8723bs: fix heap buffer overflow in rtw_cfg80211_set_wpa_ie()
supplicant_ie is a 256-byte array in struct security_priv. The WPA and
WPA2 IE copy paths use:
memcpy(padapter->securitypriv.supplicant_ie, &pwpa[0], wpa_ielen + 2);
where wpa_ielen is the raw IE length field (u8, 0-255). When a local user
supplies a connect request via nl80211 with a crafted WPA IE of length 255,
wpa_ielen + 2 equals 257, overflowing the 256-byte buffer by one byte into
the adjacent last_mic_err_time field.
rtw_parse_wpa_ie() does not prevent this: its length consistency check
compares *(wpa_ie+1) against (u8)(wpa_ie_len-2), which is (u8)(255) == 255
when wpa_ie_len = 257, so the check passes silently.
Add explicit bounds checks for both the WPA and WPA2 paths before the
memcpy, rejecting any IE whose total size (wpa_ielen + 2) exceeds the
supplicant_ie buffer. |
| In the Linux kernel, the following vulnerability has been resolved:
staging: vme_user: bound slave read/write to the kern_buf size
The SLAVE-path helpers buffer_to_user() and buffer_from_user() copy
'count' bytes into/out of the fixed-size kern_buf (size_buf ==
PCI_BUF_SIZE == 0x20000, 128 KiB) using *ppos as the offset, without
bounding *ppos + count against size_buf.
vme_user_write()/vme_user_read() only clamp count to the VME window size
(image_size = vme_get_size(resource)), which VME_SET_SLAVE sets from the
user-supplied slave.size -- validated against the VME address space (up
to VME_A32_MAX = 4 GiB), not against PCI_BUF_SIZE. When the window
exceeds 128 KiB, a write()/read() copies past the kern_buf allocation.
Clamp count against size_buf in both helpers, with an early return when
*ppos is already at/after the buffer end. *ppos is >= 0 here (the caller
rejects negative offsets), so size_buf - *ppos cannot wrap. This mirrors
the existing clamp in the MASTER-path helpers resource_to_user() /
resource_from_user(), and matches the read()/write() convention of a
short transfer at end-of-buffer.
Found by static analysis (CodeQL taint tracking + CBMC bounded model
checking) and confirmed dynamically under KASAN with the vme_fake bridge:
BUG: KASAN: slab-out-of-bounds in _copy_from_user+0x2d/0x80
Write of size 262144 at addr ffff888004100000 by task trigger/68
_copy_from_user+0x2d/0x80
vme_user_write+0x13e/0x240 [vme_user]
vfs_write+0x1b8/0x7a0
ksys_write+0xb8/0x150 |
| Out-of-bounds Write and Improper Validation of Array Index vulnerability in Samsung Open Source TizenFX Samsung/TizenFX allows Overflow Buffers. |
| There is a memory corruption vulnerability recently
discovered in NI LabVIEW that may result in information disclosure or arbitrary
code execution. Successful exploitation requires an attacker to get a
user to open a specially crafted VI. This vulnerability affects NI LabVIEW 2026 Q3 (26.3.0)
and prior versions. |
| There is a memory corruption vulnerability recently
discovered in NI LabVIEW that may result in information disclosure or arbitrary
code execution. Successful exploitation requires an attacker to get a
user to open a specially crafted VI. This vulnerability affects NI LabVIEW 2026 Q3 (26.3.0)
and prior versions. |
| There is a memory corruption vulnerability recently
discovered in NI LabVIEW that may result in information disclosure or arbitrary
code execution. Successful exploitation requires an attacker to get a
user to open a specially crafted VI. This vulnerability affects NI
LabVIEW 2026 Q3 (26.3.0) and prior versions. |
