| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| A vulnerability in the Internet Key Exchange Version 2 (IKEv2) feature of Cisco IOS Software, IOS XE Software, Secure Firewall Adaptive Security Appliance (ASA) Software, and Secure Firewall Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to trigger a memory leak, resulting in a denial of service (DoS) condition.
This vulnerability is due to a lack of proper processing of IKEv2 packets. An attacker could exploit this vulnerability by sending crafted IKEv2 packets to an affected device. In the case of Cisco IOS and IOS XE Software, a successful exploit could allow the attacker to cause the device to reload unexpectedly. In the case of Cisco ASA and FTD Software, a successful exploit could allow the attacker to partially exhaust system memory, causing system instability such as being unable to establish new IKEv2 VPN sessions. A manual reboot of the device is required to recover from this condition. |
| A vulnerability in the CLI of the Cisco Integrated Management Controller (IMC) could allow an authenticated, local attacker to perform command injection attacks on the underlying operating system and elevate privileges to root. To exploit this vulnerability, the attacker must have read-only or higher privileges on an affected device. This vulnerability is due to insufficient validation of user-supplied input. An attacker could exploit this vulnerability by submitting a crafted CLI command. A successful exploit could allow the attacker to elevate privileges to root. |
| A vulnerability in the Web Authentication feature of Cisco IOS XE Software could allow an unauthenticated, remote attacker to conduct a reflected cross-site scripting attack (XSS) on an affected device.
This vulnerability is due to improper sanitization of user-supplied input. An attacker could exploit this vulnerability by persuading a user to click a malicious link. A successful exploit could allow the attacker to execute a reflected XSS attack and steal user cookies from the affected device. |
| A vulnerability in the access control list (ACL) programming of Cisco IOS XE Software for Cisco Catalyst 9500X and 9600X Series Switches could allow an unauthenticated, remote attacker to bypass a configured ACL on an affected device.
This vulnerability is due to the flooding of traffic from an unlearned MAC address on a switch virtual interface (SVI) that has an egress ACL applied. An attacker could exploit this vulnerability by causing the VLAN to flush its MAC address table. This condition can also occur if the MAC address table is full. A successful exploit could allow the attacker to bypass an egress ACL on an affected device. |
| A vulnerability in the Layer 2 Ethernet services of Cisco IOS XR Software could allow an unauthenticated, adjacent attacker to cause the line card network processor to reset, resulting in a denial of service (DoS) condition.
This vulnerability is due to the incorrect handling of specific Ethernet frames that are received on line cards that have the Layer 2 services feature enabled. An attacker could exploit this vulnerability by sending specific Ethernet frames through an affected device. A successful exploit could allow the attacker to cause the ingress interface network processor to reset, resulting in a loss of traffic over the interfaces that are supported by the network processor. Multiple resets of the network processor would cause the line card to reset, resulting in a DoS condition. |
| A vulnerability in the web-based management interface of Cisco UCS Manager Software could allow an authenticated, remote attacker to conduct a stored cross-site scripting (XSS) attack against a user of the interface.
This vulnerability is due to insufficient validation of user-supplied input by the web-based management interface of an affected system. An attacker could exploit this vulnerability by injecting malicious data into specific pages of the interface. A successful exploit could allow the attacker to execute arbitrary script code in the context of the affected interface or access sensitive, browser-based information. To exploit this vulnerability, the attacker must be a member of the Administrator or AAA Administrator role. |
| A vulnerability in the handling of certain Ethernet frames in Cisco IOS XE Software for Catalyst 9000 Series Switches could allow an unauthenticated, adjacent attacker to cause an egress port to become blocked and drop all outbound traffic.
This vulnerability is due to improper handling of crafted Ethernet frames. An attacker could exploit this vulnerability by sending crafted Ethernet frames through an affected switch. A successful exploit could allow the attacker to cause the egress port to which the crafted frame is forwarded to start dropping all frames, resulting in a denial of service (DoS) condition. |
| A vulnerability in Cisco IOS XE Software could allow an authenticated, local attacker with level-15 privileges or an unauthenticated attacker with physical access to an affected device to execute persistent code at boot time and break the chain of trust. This vulnerability is due to improper validation of software packages. An attacker could exploit this vulnerability by placing a crafted file into a specific location on an affected device. A successful exploit could allow the attacker to execute persistent code on the underlying operating system. Because this vulnerability allows an attacker to bypass a major security feature of a device, Cisco has raised the Security Impact Rating (SIR) of this advisory from Medium to High. |
| A vulnerability in the Secure Copy Protocol (SCP) and SFTP feature of Cisco IOS XR Software could allow an authenticated, local attacker to create or overwrite files in a system directory, which could lead to a denial of service (DoS) condition. The attacker would require valid user credentials to perform this attack.
This vulnerability is due to a lack of proper validation of SCP and SFTP CLI input parameters. An attacker could exploit this vulnerability by authenticating to the device and issuing SCP or SFTP CLI commands with specific parameters. A successful exploit could allow the attacker to impact the functionality of the device, which could lead to a DoS condition. The device may need to be manually rebooted to recover.
Note: This vulnerability is exploitable only when a local user invokes SCP or SFTP commands at the Cisco IOS XR CLI. A local user with administrative privileges could exploit this vulnerability remotely. |
| A vulnerability in the VPN and management web servers of the Cisco Adaptive Security Virtual Appliance (ASAv) and Cisco Secure Firewall Threat Defense Virtual (FTDv), formerly Cisco Firepower Threat Defense Virtual, platforms could allow an unauthenticated, remote attacker to cause the virtual devices to run out of system memory, which could cause SSL VPN connection processing to slow down and eventually cease all together.
This vulnerability is due to a lack of proper memory management for new incoming SSL/TLS connections on the virtual platforms. An attacker could exploit this vulnerability by sending a large number of new incoming SSL/TLS connections to the targeted virtual platform. A successful exploit could allow the attacker to deplete system memory, resulting in a denial of service (DoS) condition. The memory could be reclaimed slowly if the attack traffic is stopped, but a manual reload may be required to restore operations quickly. |
| A vulnerability in the boot process of Cisco Access Point (AP) Software could allow an unauthenticated, physical attacker to bypass the Cisco Secure Boot functionality and load a software image that has been tampered with on an affected device.
This vulnerability exists because unnecessary commands are available during boot time at the physical console. An attacker could exploit this vulnerability by interrupting the boot process and executing specific commands to bypass the Cisco Secure Boot validation checks and load an image that has been tampered with. This image would have been previously downloaded onto the targeted device. A successful exploit could allow the attacker to load the image once. The Cisco Secure Boot functionality is not permanently compromised. |
| A vulnerability in the DHCP version 4 (DHCPv4) server feature of Cisco IOS XR Software could allow an unauthenticated, remote attacker to trigger a crash of the dhcpd process, resulting in a denial of service (DoS) condition.
This vulnerability exists because certain DHCPv4 messages are improperly validated when they are processed by an affected device. An attacker could exploit this vulnerability by sending a malformed DHCPv4 message to an affected device. A successful exploit could allow the attacker to cause a crash of the dhcpd process. While the dhcpd process is restarting, which may take approximately two minutes, DHCPv4 server services are unavailable on the affected device. This could temporarily prevent network access to clients that join the network during that time period and rely on the DHCPv4 server of the affected device.
Notes:
Only the dhcpd process crashes and eventually restarts automatically. The router does not reload.
This vulnerability only applies to DHCPv4. DHCP version 6 (DHCPv6) is not affected. |
| A vulnerability in the Remote Access SSL VPN service for Cisco Secure Firewall Adaptive Security Appliance (ASA) Software and Cisco Secure Firewall Threat Defense (FTD) Software could allow a remote attacker that is authenticated as a VPN user to cause the device to reload unexpectedly, resulting in a denial of service (DoS) condition.
This vulnerability is due to incomplete error checking when parsing an HTTP header field value. An attacker could exploit this vulnerability by sending a crafted HTTP request to a targeted Remote Access SSL VPN service on an affected device. A successful exploit could allow the attacker to cause a DoS condition, which would cause the affected device to reload. |
| A vulnerability in the Simple Network Management Protocol (SNMP) subsystem of Cisco IOS XE Software could allow an authenticated, remote attacker to cause a denial of service (DoS) condition on an affected device.
This vulnerability is due to improper error handling when parsing a specific SNMP request. An attacker could exploit this vulnerability by sending a specific SNMP request to an affected device. A successful exploit could allow the attacker to cause the device to reload unexpectedly, resulting in a DoS condition.
This vulnerability affects SNMP versions 1, 2c, and 3. To exploit this vulnerability through SNMPv2c or earlier, the attacker must know a valid read-write or read-only SNMP community string for the affected system. To exploit this vulnerability through SNMPv3, the attacker must have valid SNMP user credentials for the affected system. |
| Tinycontrol LAN Controller v3 (LK3) firmware versions up to 1.58a (hardware v3.8) contain a missing authentication vulnerability in the stm.cgi endpoint. A remote, unauthenticated attacker can send crafted requests to forcibly reboot the device or restore factory settings, leading to a denial of service and configuration loss. |
| Multiple vulnerabilities in Cisco IOS XE Software of could allow an authenticated, local attacker with level-15 privileges or an unauthenticated attacker with physical access to the device to execute persistent code at boot time and break the chain of trust.
These vulnerabilities are due path traversal and improper image integrity validation. A successful exploit could allow the attacker to execute persistent code on the underlying operating system.
Because this allows the attacker to bypass a major security feature of the device, Cisco has raised the Security Impact Rating (SIR) of this advisory from Medium to High.
For more information about these vulnerabilities, see the Details ["#details"] section of this advisory.
ERP |
| A vulnerability in the Cisco Industrial Ethernet Switch Device Manager (DM) of Cisco IOS Software could allow an authenticated, remote attacker to elevate privileges.
This vulnerability is due to insufficient validation of authorizations for authenticated users. An attacker could exploit this vulnerability by sending a crafted HTTP request to an affected device. A successful exploit could allow the attacker to elevate privileges to privilege level 15.
To exploit this vulnerability, the attacker must have valid credentials for a user account with privilege level 5 or higher. Read-only DM users are assigned privilege level 5. |
| A vulnerability in the management and VPN web servers of the Remote Access SSL VPN feature of Cisco Secure Firewall ASA Software and Secure FTD Software could allow an unauthenticated, remote attacker to cause the device to unexpectedly stop responding, resulting in a DoS condition.
This vulnerability is due to ineffective validation of user-supplied input during the Remote Access SSL VPN authentication process. An attacker could exploit this vulnerability by sending a crafted request to the VPN service on an affected device. A successful exploit could allow the attacker to cause a DoS condition where the device stops responding to Remote Access SSL VPN authentication requests. |
| A vulnerability in the local interface of Cisco BroadWorks Network Server could allow an unauthenticated, remote attacker to exhaust system resources, causing a denial of service (DoS) condition.
This vulnerability exists because rate limiting does not occur for certain incoming TCP connections. An attacker could exploit this vulnerability by sending a high rate of TCP connections to the server. A successful exploit could allow the attacker to cause TCP connection resources to grow rapidly until the Cisco BroadWorks Network Server becomes unusable.
Note: To recover from this vulnerability, either Cisco BroadWorks Network Server software must be restarted or the Cisco BroadWorks Network Server node must be rebooted. For more information, see the section of this advisory.
Cisco has released software updates that address this vulnerability. There are no workarounds that address this vulnerability. |
| A vulnerability in the CLI of Cisco Secure Firewall Management Center (FMC) Software and Cisco Secure Firewall Threat Defense (FTD) Software could allow an authenticated, local attacker to execute arbitrary commands on the underlying operating system as root.
This vulnerability is due to improper input validation for specific CLI commands. An attacker could exploit this vulnerability by injecting operating system commands into a legitimate command. A successful exploit could allow the attacker to escape the restricted command prompt and execute arbitrary commands on the underlying operating system. To successfully exploit this vulnerability, an attacker would need valid Administrator credentials.
For more information about vulnerable scenarios, see the Details ["#details"] section of this advisory. |
