| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
netfilter: xt_multiport: validate range encoding in checkentry
ports_match_v1() treats any non-zero pflags entry as the start of a
port range and unconditionally consumes the next ports[] element as
the range end.
The checkentry path currently validates protocol, flags and count, but
it does not validate the range encoding itself. As a result, malformed
rules can mark the last slot as a range start or place two range starts
back to back, leaving ports_match_v1() to step past the last valid
ports[] element while interpreting the rule.
Reject malformed multiport v1 rules in checkentry by validating that
each range start has a following element and that the following element
is not itself marked as another range start. |
| In the Linux kernel, the following vulnerability has been resolved:
ext4: validate p_idx bounds in ext4_ext_correct_indexes
ext4_ext_correct_indexes() walks up the extent tree correcting
index entries when the first extent in a leaf is modified. Before
accessing path[k].p_idx->ei_block, there is no validation that
p_idx falls within the valid range of index entries for that
level.
If the on-disk extent header contains a corrupted or crafted
eh_entries value, p_idx can point past the end of the allocated
buffer, causing a slab-out-of-bounds read.
Fix this by validating path[k].p_idx against EXT_LAST_INDEX() at
both access sites: before the while loop and inside it. Return
-EFSCORRUPTED if the index pointer is out of range, consistent
with how other bounds violations are handled in the ext4 extent
tree code. |
| Improper Neutralization of Delimiters vulnerability in Cesanta Mongoose Web Server v7.14 allows to trigger an infinite loop bug if the input string contains unexpected characters. |
| Improper Neutralization of Delimiters vulnerability in Cesanta Mongoose Web Server v7.14 allows to trigger an out-of-bound memory write if the PEM certificate contains unexpected characters. |
| Integer Overflow or Wraparound vulnerability in Cesanta Mongoose Web Server v7.14 allows an attacker to send an unexpected TLS packet and produce a segmentation fault on the application. |
| Net::IP::LPM versions before 1.11 for Perl allow a heap out-of-bounds read via an unbounded prefix length.
add() passes the prefix string to the trie builder addPrefixToTrie() without checking it against the address width.
addPrefixToTrie() then walks the prefix buffer by prefix_length bits, reading prefix[byte] for byte up to prefix_len/8, where prefix is the 4-byte (IPv4) or 16-byte (IPv6) packed address. A prefix length greater than 32 for IPv4 or 128 for IPv6, for example add("1.2.3.4/255", $v) or add("2001:db8::/255", $v), reads past the end of the packed address.
The out-of-bounds read happens during trie construction and is bounded: the prefix length is stored as an unsigned char, so the bit walk reads at most 32 bytes from the start of the packed address, a short distance past the end of the 4-byte or 16-byte buffer. It is detectable under AddressSanitizer, valgrind, or a hardened allocator, where it can abort the process. Lookups and dump() format only the valid address width, so the out-of-bounds bytes are not exposed through the module's API. |
| Net::IP::LPM version 1.10 for Perl does not properly consider leading zero characters in IP CIDR address strings, which could allow attackers to bypass access control that is based on IP addresses.
Leading zeros are used to indicate octal numbers, which can confuse users who are intentionally using octal notation, as well as users who believe they are using decimal notation. |
| In Power HAL, there is a possible out of bounds write due to a missing bounds check. This could lead to local escalation of privilege if a malicious actor has already obtained the System privilege. User interaction is not needed for exploitation. Patch ID: ALPS11165543; Issue ID: MSV-9011. |
| In the Linux kernel, the following vulnerability has been resolved:
crypto: sun8i-ss - Remove crypto_rng interface
Since the crypto_rng interface for hardware PRNGs is unused and is
redundant with hwrng and the actual Linux RNG, it's being phased out.
Most drivers for it were already removed. Go ahead and remove the
sun8i-ss support which is one of the only remaining ones.
As usual for crypto_rng, this driver was also buggy: its ->generate()
function had a use-after-free vulnerability due to using
wait_for_completion_interruptible_timeout() without handling shutting
down the DMA operation if a signal is sent. Also, it had a buffer
overread bug in the line 'memcpy(ctx->seed, d + dlen, ctx->slen);'.
There's no point in fixing these bugs separately only to remove the code
anyway, so this commit is marked with Fixes and Cc stable. |
| In the Linux kernel, the following vulnerability has been resolved:
nsfs: tighten permission checks for handle opening
Even privileged services should not necessarily be able to see other
privileged service's namespaces so they can't leak information to each
other. Use may_see_all_namespaces() helper that centralizes this policy
until the nstree adapts. |
| In geniezone, there is a possible information disclosure due to a missing bounds check. This could lead to local information disclosure if a malicious actor has already obtained the System privilege. User interaction is needed for exploitation. Patch ID: ALPS10867524 / ALPS10876355; Issue ID: MSV-6674. |
| Tobit Laboratories AG TeamDavid's Webbox application handles password changes using a function triggered by
including the string "(editini)" in the file path, writing the new
password to the specified "Archive.ini" file. However, the application
does not verify that the provided path actually refers to an
"Archive.ini" file. If an attacker specifies a different file with
excessive size, a buffer overflow occurs. This vulnerability allows an
unauthenticated attacker to crash the server, resulting in denial of
service. This issue affects TeamDavid before Rollout 528.
Starting with Rollout 528 (June 30, 2026), the affected functionality is disabled by default and the vulnerabilities are therefore no longer exposed through this functionality. |
| A flaw was found in libtpms, a library that provides software TPM 2.0 emulation. When restoring TPM 2.0 state (for example during a virtual machine's power-on or state/migration restore), a malformed state blob can supply an oversized skip-block length that is not validated against the remaining size of the input buffer. This can drive an internal size counter negative, which bypasses a subsequent bounds check due to an unsafe signed-to-unsigned conversion, causing the parser to read memory outside the bounds of the heap buffer holding the state data. Successful exploitation can crash the process hosting libtpms (such as swtpm), resulting in a denial of service of the emulated TPM device and the virtual machine that depends on it. No data corruption or information disclosure was confirmed. |
| Out-of-bounds read vulnerability in Samsung Opensource rLottie allows Overread Buffers.
This issue affects rLottie: 25648aef19187b3f87f4d9420b8d761453ad4630. |
| MOOS-IvP through 24.8.1 contains a buffer over-read vulnerability in isQuoted(), isBraced(), and isChevroned() functions that strip whitespace but index using the original string length. Attackers can send NODE_REPORT messages with leading or trailing whitespace to read past buffer bounds and access adjacent memory. |
| toml-node is a TOML parser for Node.js and the browser. Prior to 4.1.2, toml.parse() in lib/compiler.js can be tricked by a table path such as a.b.y.__proto__.__proto__, allowing traversal from a scalar value into Number.prototype and Object.prototype. The currentPath tracking value uses both arrays and strings, so valueAssignments records a comma-joined path such as a,b.y while deepRef checks the dot-joined path a.b.y, allowing the duplicate-key guard to miss and attacker-controlled keys to be written to Object.prototype. A table-array prefix-clearing path in addTableArray can also erase guard state before the same __proto__ traversal. Injected properties become visible throughout the Node.js process and can cause denial of service, logic or authorization bypass, or code execution when an application contains a suitable gadget. This issue is fixed in version 4.1.2. |
| A security vulnerability was discovered in Fleet's Helm template preprocessing where templates evaluated by the Fleet controller could reach network resources outside the management cluster. A user who can supply bundle content to a repository referenced by a `GitRepo` resource can cause the Fleet controller to:
- Disclose cluster metadata available to the templating context.
- Reveal information about hosts reachable from the controller's network position.
Because the disclosure channel is name resolution, it may remain effective in environments where outbound traffic is otherwise restricted. The disclosed information is limited to values exposed to the Fleet templating context and to name resolution results. Integrity and availability of managed clusters are not affected.
This issue affects Fleet:
from 0.12.0 before 0.12.19,
from 0.13.0 before 0.13.15,
from 0.14.0 before 0.14.10,
from 0.15.0 before 0.15.6, and
from 0.16.0 before 0.16.1. |
| YesWiki is a wiki system written in PHP. Prior to version 4.6.6, the recentchanges action (actions/recentchanges.php) accepts a period argument from two disjoint parameter spaces. A whitelist validates only the URL form against ['day','week','month']. The action-argument form takes the else branch with no validation, and the value flows into PageManager::getRecentlyChanged(), where it is interpolated into a WHERE time >= '...' ORDER BY time DESC clause without escaping or parameterization. UNION-based injection succeeds, the leaked rows render into the response page, so any visitor of the trigger page sees the exfiltrated data. The vulnerability provides arbitrary read of the YesWiki database to anyone who can save the trigger page. On a default install (default_write_acl='*'), this includes anonymous users, subject to the hashcash JS check on the page-edit form. Once the trigger page is saved, every subsequent view fires the injection as the SQLi is stored. Stored SQL injection is reachable through the page-edit flow, with arbitrary database read. This issue has been patched in version 4.6.6. |
| FreeRDP before 3.31.0 contains a heap out-of-bounds read vulnerability in the general_ChromaV1ToYUV444 function during AVC444 chroma plane reconstruction. A malicious RDP server can craft a RFX_AVC444_BITMAP_STREAM with specific frame geometry to trigger an out-of-bounds memory read past the allocated luma plane. |
| In the Linux kernel, the following vulnerability has been resolved:
nfc: microread: validate target discovery payload lengths
microread_target_discovered() parses target discovery payloads from
skb->data according to the HCI gate. The fixed field offsets and UID
copies were checked only against the destination nfc_target buffers, not
against the actual skb length.
Validate that each gate-specific payload contains the fixed fields and
UID bytes before reading or copying them. |
